User Guide
User Guide
User Guide
|
Use it! |
(3D only) Used to fillet, or round, one or more edges of a solid, projected surface, or a surface of revolution. To use this tool:
Select the edge you want to fillet.
To select additional edges, press <Ctrl> and, as you move the pointer over the solid or surface, the edge nearest the pointer highlights. While holding down <Ctrl>, enter a data point to select the additional edge.
You can enter a Reset to deselect an incorrect edge. Where a number of edges have been selected, consecutive Resets will deselect them in the reverse order (that is, the last edge selected is the first edge deselected).
Tool Setting | Effect |
---|---|
Radius | Defines the radius of the fillet. |
Select Tangent Edges | If on, edges that are tangentially continuous are selected and rounded in one operation. If off, only the selected section is filleted. |
Applying fillets to edges of a solid (Top) and a projected surface (Bottom). Left: Identify the edges (1 and 2), which highlight. Accept (3) to fillet the selected edges. | |
Effect of “Select Tangent Edges” setting. Left: Off — only the identified section of the edge is selected for filleting. Right: On — the identified section plus all edges that are tangentially continuous are selected for filleting. | |